Telion LogoTelion LogoTelion Logo
  • Home
  • About us
  • Shop
  • Blog
  • Printer Features
    • Printer Specifications
    • Strong Printer Frames
    • Bearings and Spindle
    • Lift Platform
    • Printer bed and lift platform
    • Printer bed heating
    • Printer bed surfaces
    • Coarse print bed levelling
    • Fine print bed levelling
    • Printer illumination
    • Extruder tip illumination
    • Extruder fine adjustment
    • Bowden filament drive
    • Draft Shield Assembly
  • Videos
  • Galleries
    • 3D Printer Assembly Steps
    • 3D Printer Printed Examples
  • Forum
  • My Account
  • Downloads
    • Public Downloads
    • Member Downloads
  • Contact us
0
The heated print bed with a borosilicate glass print surface. To remove the print bed assembly.
Disconnect the heater and temperature sensor.
Print bed disconnected.
Un-hook the 4 springs.
Un hook springs.
Un hooked spring.
Once all spring are un hooked. Lift the print bed assembly off the lift platform.
Print bed assembly removed from lift platform.
Front right 50x6mm grub screw - Print bed support.
Back center 50x6mm grub screw - Print bed support.
To re-install the print bed assembly. Lay the print bed assembly onto the 3 pointed 50x6mm grub crews, take care the grub-screw- points locate to the holes of the print bed assembly.
Use a wire to grab, stretch and engage the 4 springs
Spring re-installed.
Re connect the heater and temperature sensor. Level the print-bed wth the 3 M6x50mm grub screws.
  • Shop
  • Cart
  • Site map
  • Blog
  • Forum
  • Galleries
  • Printer Features
  • Videos
  • Downloads
  • My account
  • Contact us
  • Terms & conditions
© 2016 Telion. All Rights Reserved.
Web Design by : webdesignipswich.com.au